Es | En

Contacto: 01-800-21-MECAL

APLICADORES - IDC AMP MODU

Aplicador - IDC AMP MODU

DESCRIPCIÓN

The applicator Restyling IDC Pneumatic is an economical solution for crimping Insulation Displacement Connectors. In this configuration, the product is specific to the connector of the family Tandem Spring AMPMODU MT. Applicable to all presses with standard attacks and working height equal to 135.8mm (available on request different working heights).

The connectors are loaded manually on a special loader steel which guarantees the position and the polarization of the connector itself and the position of the pin inserted board. The pneumatic feed is controlled by a series of sensors that allow you to crimp the pins, step by step, regardless of the number of routes, and perform a translation with different pitch at the end of each complete set of crimping. A sensor controls the positioning of the optical cable to crimp. The cable entry is via a dedicated pin in the clamping gripper.







 ID

MRSP – IDC AMPMODU  

  CRIMPING HEIGHT

135,8mm (5,346")  

  STROKE

40/30mm (1,575/1,18")  

  TERMINAL PITCH

2,5mm. Connectors mounted  

on a mechanical loader  

  WIRE SECTION

from 0.3 to 0.6 mm²  

  FEEDING SYSTEM

Air pipe D6  

pressure 5/6 Bar  

  WEIGHT

8,0 Kg (17,6 lb)  

  DIMENSIONS

W638xH145,5xD152(mm)  

(W25,1“xH5,72”xD5,98”)  

  AIR CONSUMPTION

0,36 dm³/min  

  CYCLE TIME

1,8 sec  

  LOADING TIME
  2X3 PIN CONNECTORS

100 sec. (N°27 connettors)  

  LOADER

Customized according to the  

connector ways number.  

No adjustment needed  

on the applicator